Products

TensorGrip C11 Performance Panel Adhesive

$899.00

As part of TensorGrip’s CONSTRUCTION range, TensorGrip C11 is a web spray adhesive suitable for FRP/GRP and polystyrene applications.

 

  • High solids.
  • High temperature resistance.
  • Polystyrene and EPS compatible.
  • Designed for bonding exterior grade substances to foam many other substances.
Clear
SKU: TG-C11 Category:
Description

TensorGrip C11 Performance Panel Adhesive

 

TensorGrip C11 is an extra high performance, panel bonding adhesive formulated specifically to bond insulated panel materials to GRP and Plywood (as well as EPS and polystyrene). C11 is a fast drying formula that has excellent high coverage designed for bonding exterior grade substrates to insulated foam. This formula has excellent resistance when dealing with moisture and extreme weather exposure.

TensorGrip C11 Directions For Use

 

This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60 degrees F – 80 degrees F (16degrees C – 27 degrees C).

 

Use with adequate ventilation. When possible we recommend shaking the canister well before using. Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.

 

Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm (4” – 8”) away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both
surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.

 

Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.

 

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice.

 

TensorGrip C11 Storage/Change Over

 

Turn valve on canister into the off position, spray out remaining adhesive left in the hose, disconnect the spray hose and gun from the canister. Reconnect the spray hose to a canister of cleaning solvent (sold separately) and spray out until liquid is clear which indicates that the hose and gun is clean. If you choose to leave the hose and spray gun on the canister, leave the valve on the canister open. Do not disconnect the hose/gun from the canister. Close and lock the spray gun.

Features
  • High solids.
  • High temperature resistance.
  • Polystyrene and EPS compatible.
  • Designed for bonding exterior grade substances to foam many other substances.
Applications

TensorGrip C11 has been developed for:

  • FRP/GRP Applications
  • Polystyrene Applications

 

Downloads